Peugeot 208 Key Replacement
It is best to leave the replacement of Peugeot 208 keys to auto locksmiths that have the required equipment and skills. peugeot 107 spare key can create and program keys faster and less expensive than dealers.
A dead coin battery is most likely to be at fault the reason why your key fob isn't locking or unlocking doors. However, there are many other possibilities that the key is malfunctioning.
Dead Coin Battery
A dead coin battery will stop your Peugeot 208 from locking and unlocking, as well as stopping it from starting the engine. If this is the situation, you'll need make use of the backup starting procedure that is described in the owner's manual for your vehicle.
The spark plugs can also be worn out. The spark plugs are responsible for sparking the fuel which starts the engine. However they have a short lifespan. They will eventually break down when they aren't used enough.
Luckily, there is an easy solution for this problem. The best option is to determine the voltage of your car battery using a multimeter. If it's less than 11.5 volts then you must replace it. It is also essential to clean the contacts of the battery in case it is corroded. You can do this by lifting the rubber covers that cover the two terminals of the battery and using wire brushes to clean any corroded components of the battery. Then, you should reconnect the positive pole cables to the negative.
Water Damage
If your 208 won't start and the battery is not flat, then you need to make sure that the spark plugs are working. You may find that they are dirty and they don't spark. The spark plugs can be cleaned in the workshop.
Peugeot cars use transponder keys that integrates with the car's immobiliser system. This guarantees that only the right key is able to turn the engine. If the chip inside the Peugeot key is damaged, it will not send the correct signal to the vehicle.
This is a very common issue that is caused by water damage. This is a common issue in colder climates where the vehicle is exposed to rain or snow. If this is the case, seek out a reputable auto locksmith who will have all of the equipment and tools needed to reprogram the new key. They also have the most up-to-date technological know-how and the equipment required to make the Peugeot 208 smart key. The process should take no more than 15 minutes.
Contacts of the battery may be damaged.
Peugeot replaced the old transponder chips using a new model that utilizes electronic components that are mounted on a circuit board. The new system is excellent in its initial state, but the circuit boards begin to degrade with time and stop working properly.
This can stop the immobiliser from activating so the vehicle won't start. If this is the case, it's a good idea to contact a Peugeot specialist or locksmith.
The most frequent issue is when the battery in the key fob begins to die. This causes the blade of the key to stop feeding into your lock. A locksmith for cars can replace the battery and cut a fresh blade for you, it's usually a simple fix.
Faulty Receiver Module
It could be that the receiver module is malfunctioning in the event that your Peugeot key fob fails to function after being dropped on the floor, or exposed to a sudden storm or accidentally washed. The receiver module is responsible for transmitting radio signals to the onboard computer that manages the central locking system of your Peugeot vehicle.
The rubber seals on the key fob keep water from reaching the electronic chip. Water can damage the chip when exposed to water for a prolonged period of period of. The high salt content of the ocean or pool can cause damage to the key fob, especially if it is submerged.
If your Peugeot spare key fob stops working then you'll have to get the module replaced. This should be done by an Peugeot specialist or expert auto locksmith. Peugeot keys unlike other automobiles, are protected by an immobilizer system. This requires the right coding to start the car. This is the reason that you should only trust an authorized Peugeot locksmith to design and program the replacement.
Computer with a problem on board
The computer on board of your Peugeot is responsible many functions in your car including airbags and power windows. The on-board computer will show a code when something goes wrong. The code is stored within the system and remains there until the issue is fixed. This will often require the on-board computers to be replaced.
The most common reason for the warning light for the airbag to illuminate is corrosion or loose connections within the sensor. It can be due to wear and tear, aging or exposure to salt and moisture. This issue needs to be taken care of as soon as you can, as an airbag that is not functioning could be dangerous in the event of an accident.
If you notice an error message stating that the card is not found on your Peugeot, the key battery in the key fob could be weak or dead. This will stop the key fob sending a signal to deactivate the vehicle's immobilizer. You can test this by pressing the unlock button on the key fob, then trying to start your vehicle. If this does not work then the battery in the key needs to be replaced.